Hi everyone, first time poster, long time lurker.
Just installed a new Intake Manifold and other fun/difficult hoses on my 2013 (Mk6) Golf 2.5L and wanted to throw anyone a bone before pitching the OEM plastic pieces into recycling.
Happy August Long! Drive Safe!
I have a 1985 Mk1 Cabrio with the stock steering wheel with 4 horn buttons. The 2 buttons on the left do not work. The 2 on the right work perfectly. Any help on how to remove them to inspect the connections?
There is a small arrow pointing towards the center of the steering wheel on the...
I have a 2007 triple white beetle convertible that... sadly... needs new headlights (plastic lenses are clouded over and restoration only goes so far). With that said... I need to replace/upgrade them without doing anything illegal. With that said, are there specific lights that are...
Long story short. 2010 CC 2.0t with dsg trans. Car was in an accident and when the wrecker pulled it back it tore the lower front bumper off with assorted other plastic pieces. Including the lower half of the radiator support and everything below that. The ambient air temp sensor is gone and...
Hi everyone, new to the forum from Newnan, GA USA. We have a 2017 Tiguan Limited 2.0 TSI that's due for an oil change. I need to know how to detach the plastic belly pan(splash pan?) under the engine to access the oil pan drain plug? I see the 2 T45 bolts and removed the 9 or so T20 screws...
could someone tell me the name of the hose , i think its a vacuum hose, that bolts to the bottom of the intake manifold top(the part that you see when you open the bonnet) its rigid plastic and runs from the left side of the engine to the right
Our Golf 7 is just four years old but the headlamp lenses are already losing their shine and becoming slightly opaque. I spoke to the dealer about this last time the car was serviced and he said that it was basically the sunshine denaturing the plastic. "Try to park out of the sun", was his...
1997 Mexican Beetle has the larger plastic rear light cluster triple glasses.
Bought new ones to replace very faded existing, but seal very badly to fitted body seals. Old ones did too as gunk all over them on removal.
Does anyone know a trick here or better seals or products to help.
Touareg dog guard that has been removed from a 2007 Altitude.
Also the heavy duty plastic liner tray for the boot-this part is now discontinued.
The boot tray fits Touareg 2004-2010.
Brilliant for dogs!
This has signs of use but in good condition. I have photos but can’t upload!
Hi, I'm a super newbie to VW, this 81 deisel rabbit is my first. I'm having fuel leak issues due to not having all the proper fuel lines lol. It's a project car. However, I can't seem to find which hose is which in the manual I have.
I also am unsure of the hose sizes I need.
I just need a...
Hi all, this is my first post. Thanks for letting me join.
I have removed my cup holder from front dash as it was broken. Bought a new one and it says with models below year 2000, will need to remove centre plastic strip at rear of surround it slots into. Basically because it won't quite sit...
Is it me or do all reviewers follow the same script?
Conservative styling will age well, but boring.
Huge back seat legroom and decent headroom, before discussing front seating, dash.
Light steering, too much lower hard plastic and too small infotainment screen.
For me the V6 Passat is a...
I took the plastic bumper off my 2013 passat (European version) today and found a rather crumpled impact bar.
The car is second-hand and I wasn't aware of any previous accidents, should I be worried by this?
My first post.
I would like to have driving lights installed in the OEM locations on my 2013 2.5 SE. I was told by various dealers that it's impossible. Is there any way it can be done . I'm disappointed at VW. I had the dealer install them in my 2015 Subaru Forester no sweat...
I have a 2003 Mk4 which has the usual terrible corrosion on the exterior tailgate handle. I'm just wondering if I should buy a metal original in correct colour from a scrap dealer (has just a tiny bit of corrosion) or buy a plastic replacement and respray? Cost wise it's similar, but which...
Does anybody now if I can take the radio from a Passat 2003 and put it to my Passat from 2000?
I suppose it will fit if I move the hole plastic frame but is it the same contacts, and if, will the radio work?
I want to take this radio:
And put in my older Passat: