Volkswagen Owners Club Forum banner
1 - 1 of 1 Posts

Super Moderator
10,703 Posts
Discussion Starter · #1 · (Edited)
Well today I was pondering to send a friend of mine the weighted Billet from Missing Linkz for a present.
I bought one for my 90, along with the short shifter kit, and it rocked.

Since I'm a cheap bastard (cost effective), I have come up with a home Brew version that uses no clamps, and is a easy retro when you do a bushing swap.

One and a half Pounds of fender washers. Large Diameter Internal hole.
2 wire ties
Roll of electrical tape.

Take of the shifter link, and slide the washers over the rod one at a time.
Center the mass, and one the edges apply a wire tie to keep them all together.
Cover with electrical tape to water proof.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.