Volkswagen Owners Club Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Can the electronic emergency brake system running tension be adjusted using a scan tool? Once emergency brake is released , there seems to be too much retained pressure between pads and rotor. Brake pads are new, I just replaced. Caliper slides greased, free moving. backed out the e-brake prior to start of job( backed out using a 12v battery applied to motor at each rear caliper). After installing new pads, I pumped brake pedal couple times, then
Applied e brake via e- brake switch, located in center console. E brakes wound down to meet pads and e brake holds , but when I release e brake, there seems too much tension, pads are quite tight too rotors. Can this tension be reduced using scan tool at dealership?are
 
1 - 1 of 1 Posts
Top