[Gaffers01]

I have just replaced the accelerator pedal on my vw tiguan 2008 and there is no acceleration. It's an automatic and when I drive it, it just goes slowly until it changes gear then accelerates a bit and so on.
I've tried it in manual but same thing.
Is there a setting that I need to do as the pedal got replaced? (it had snapped as there was a stone stuck under it).

 

[watergate528]

I have just replaced the accelerator pedal on my vw tiguan 2008 and there is no acceleration. It's an automatic and when I drive it, it just goes slowly until it changes gear then accelerates a bit and so on.
I've tried it in manual but same thing.
Is there a setting that I need to do as the pedal got replaced? (it had snapped as there was a stone stuck under it).

Try this.......
Reset accelerator pedal sensor?
To recalibrate the ECM and accelerator pedal, the ignition switch must be in the ON position and then the accelerator pedal must be slowly and fully depressed from idle to full throttle. Repeat the procedure three times.