Torque converter won't seat
My girlfriends 2010 jetta 2.5 with the (09G) automatic transmission.
Doing a engine replacement due to timing chain being stretched and high km.
I split the transmission from the engine and didn't think to remove the nuts holding the TC to the fly wheel. So it all came apart but the TC was still mounted to the engine, removed it and now mounting it all together again the TC just wont seat properly the input shaft somehow I can't even manage to get the first drop or even turn it much. Any tips or info would be highly appreciated since I been trying to deal with this for the past few hours
Doing a engine replacement due to timing chain being stretched and high km.
I split the transmission from the engine and didn't think to remove the nuts holding the TC to the fly wheel. So it all came apart but the TC was still mounted to the engine, removed it and now mounting it all together again the TC just wont seat properly the input shaft somehow I can't even manage to get the first drop or even turn it much. Any tips or info would be highly appreciated since I been trying to deal with this for the past few hours
1 - 1 of 1 Posts
1 - 1 of 1 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Volkswagen Owners Club Forum
A forum community dedicated to all Volkswagen owners and enthusiasts. Come join the discussion about performance, TDI, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Recommended Communities
